Turbo-action 14156 Torqueflite 404, 413, 470 and Neon Manual Va Manuel d'utilisateur télécharger pdf

Part #14156N 8/06/03,05/30/07

1535 Owens Road, Jacksonville, FL 32218

Phone (904) 741-4850 *** FAX (904) 741-4853

www.turboaction.com

Part #14156N 1981-2000

CHEETAH Manual Valve Body - PRN123 - Reverse Pattern (Non-Lock-Up)

Improved Performance over #14156 Valve Body

Torqueflite 404, 413, 470 and Neon 30TH/31TH Non Lock-Up & Lock-Up

(For Competition Drag Strip Use Only)

Installation Instructions

FIRST, READ INSTRUCTIONS CAREFULLY, THEN PROCEED TO INSTALL VALVE BODY BY FOLLOWING EACH

STEP INDIVIDUALLY.

Kit Includes: 1 - 14156N Valve Body

1 - 14063C Pan Gasket

1 - U14040 Expansion Plug (For Lock-Up Models)

1 - U23138 Socket head 3/8”-16 set screw (For late model with bypass pipe)

STEP #1: Be sure car is in park and rear wheels blocked.

STEP #2: Open hood and locate kickdown linkage and shifter linkage. Use 10mm wrench or socket and loosen up.

(Do not take bolts out completely). Then very carefully pry up linkage and remove wiring to the Lock-Up

Connecter if equipped. (Fig. #1 & #2)

STEP #3: Jack car front end up per car manufacturer’s specifications. CAUTION: Front wheel drive cars must be

jacked properly or possible damage may occur. Also, you must block rear wheels when jacking car up.

STEP #4: Remove pan bolts (13mm) starting with the rear and working forward. NOTE where the neutral safety wire

harness bracket goes. Leave two bolts at front of pan loosely attached. Now carefully pry the rear

of the pan and let oil drain off before dropping pan. (Fig. #3)

STEP #5: Notice in corner of the pan is a magnet some models. Clean it before reinstalling pan.

STEP #6: Remove two screws, which hold filter. Be careful to not lose the filter gasket. Note: Three screw filter from

1981-82 404/413/470 is thinner dacron material and is only used with shallow pan. The 1983-Up is thicker

and is steel and plastic encasing a dacron material and requires a deep pan.(Standard on Neons,Fig #4 & #8).

STEP #7: Remove parking rod and “E” clip. (Fig. #5)

Note: This transmission requires some special tools to be worked on. The following tools will be

required: 1 - Torx T25 Screwdriver

1 - 10mm Socket

1 - 13mm Socket

1 - 18mm Socket or Wrench

1 - 8mm Open End Wrench

1 2 3 4

Résumé du contenu

Page 1 - Part #14156N 1981-2000

Part #14156N 8/06/03,05/30/071535 Owens Road, Jacksonville, FL 32218Phone (904) 741-4850 *** FAX (904) 741-4853www.turboaction.comPart #14156N 1981-

Page 2

Part #14156N 8/06/03, 05/30/07STEP #8: Remove seven 10mm valve body bolts. There are three in front and four in the rear. You must hold valvebody

Page 3 - Fig. #5 Fig. #6

Part #14156N 8/06/03,05/30/07Fig. #1 Fig. #2Fig. #3 Fig. #4Fig. #5 Fig. #6

Page 4 - Fig. #11

Part #14156N 8/06/03, 05/30/07Fig. #7 Fig. #8Fig. #9 Fig. #10Fig. #11

Commentaires sur ces manuels

Pas de commentaire

Turbo-action 14156 Torqueflite 404, 413, 470 and Neon Manual Va Manuel d'utilisateur

Naviguer en ligne ou télécharger Manuel d'utilisateur pour Pour la voiture Turbo-action 14156 Torqueflite 404, 413, 470 and Neon Manual Va. Turbo Action 14156 Torqueflite 404, 413, 470 and Neon Manual Valve Body (PRN123) User Manual Manuel d'utilisatio

Résumé du contenu

Commentaires sur ces manuels

Produits connexes et manuels pour Pour la voiture Turbo-action 14156 Torqueflite 404, 413, 470 and Neon Manual Va