Turbo-action 17880XA Torqueflite 727, 904, 998 & 999 Pro Ra Manuel d'utilisateur télécharger pdf

Part #17880XA 8-14-14

1535 Owens Road, Jacksonville, FL 32218

Phone (904) 741-4850 *** FAX (904) 741-4853

www.turboaction.com

This valve body will give excellent results when properly installed, but care must be taken to read

these instructions very carefully. This valve body can be installed much easier if transmission is

cool. A new transmission filter is recommended, #17013 Filter, but not necessary.

FRONT BAND (Kickdown) ADJUSTMENT (If Wedge or Hemi Band): Adjust front band per the

following specs - (a) Locate the adjustment on driver’s side on the outside of the transmission, just

ahead of the linkage. (b) You will need a 3/4” wrench and an open end 5/16” wrench. Break the

locknut loose (3/4” nut). Now holding the locknut, turn the square lug in the center of the locknut

with your 5/16” open end wrench. Turn wrench clockwise until wrench becomes snug (10 in./lbs.).

Make sure locknut doesn’t move while tightening the square lug. (c) Now carefully turn 5/16”

wrench counter clockwise 1 1/2 (6 Flats) turns. Holding the 5/16” wrench, tighten the 3/4” wrench

to 35 ft./lbs. (very tight). DO NOT allow the square lug to move while tightening the 3/4” locknut.

STEP #1: If vehicle is on the ground, secure so it will not roll. (Preferably, vehicle should

have all four wheels off the ground.) Place vehicle shift selector in park range.

Remove throttle pressure linkage and gear selector linkage located on the

driver’s side of the vehicle. Disconnect only at the shaft coming out of the trans-

mission case. You will note the two linkage levers on the shaft are fastened by a

bolt in each case. Loosen these bolts but do not remove bolts completely. After

loosening bolts, carefully pry levers upward with a screwdriver. The top (throttle

pressure) lever is no longer needed.

STEP #2: Remove all pan bolts but two on one end. This way you will be able to drain the

transmission without getting soaked with oil. These two bolts can be gradually

loosened off after most of the oil has been drained.

Special Characteristics about your Cheetah Valve Body:

1. First Gear -

no engine compression braking.

2. First to second shift on jackstands will not be noticeable, unless you hold

your foot on brake as you make the shift.

3. Second to third shift will be vastly improved.

4. There is no line pressure reading at center check point in case. If pressure

reading is desired, check on front servo in high gear (105 lbs.)

CHEETAH Manual SP Valve Body - PRN321 Stock Pattern

Part # 17880XA -Torqueflite 727 & 904 1966-Up Non Lock-Up

(Competition Drag Strip Use Only)

IMPORTANT - Water Burnout Instructions on Page 4.

-1-

1 2 3 4 5 6 7 8

Résumé du contenu

Page 1 - PRN321 Stock Pattern

Part #17880XA 8-14-141535 Owens Road, Jacksonville, FL 32218Phone (904) 741-4850 *** FAX (904) 741-4853www.turboaction.comThis valve body will

Page 2 - , 7/23/02

Part #17880XA 8-14-14STEP #3: Carefully remove the ten 7/16” bolts which hold the valve body in place (Fig. #1).Slowly pull valve body out of t

Page 3

Part #17880XA 8-14-14Fig. #1 Remove Ten Bolts Fig. #2 Park RodFig. #3 Remove Spring(s)Fig. #5 Neutral Safety SwitchFig. #4 Remove E-ClipFig

Page 4 - Water Burnout Instructions

Part #17880XA 8-14-14Water Burnout InstructionsTire development brought about the need to get tires hot in order to get maximum traction. Thiss

Page 5

Part #17880XA 8-14-141535 Owens Road, Jacksonville, FL 32218Phone (904) 741-4850 *** FAX (904) 741-4853www.turboaction.comThis valve body will

Page 6

Part #17880XA 8-14-14STEP #3: Carefully remove the ten 7/16” bolts which hold the valve body in place (Fig. #1).Slowly pull valve body out of t

Page 7

Part #17880XA 8-14-14Fig. #1 Remove Ten Bolts Fig. #2 Park RodFig. #3 Remove Spring(s)Fig. #5 Neutral Safety SwitchFig. #4 Remove E-ClipFig

Page 8

Part #17880XA 8-14-14Water Burnout InstructionsTire development brought about the need to get tires hot in order to get maximum traction. Thiss

Commentaires sur ces manuels

Pas de commentaire

Turbo-action 17880XA Torqueflite 727, 904, 998 & 999 Pro Ra Manuel d'utilisateur

Naviguer en ligne ou télécharger Manuel d'utilisateur pour Pour la voiture Turbo-action 17880XA Torqueflite 727, 904, 998 & 999 Pro Ra. Turbo Action 17880XA Torqueflite 727, 904, 998 & 999 Pro Race Only Manual Valve Body (PRN321) User Manual Manuel d'utilisatio

Résumé du contenu

Commentaires sur ces manuels

Produits connexes et manuels pour Pour la voiture Turbo-action 17880XA Torqueflite 727, 904, 998 & 999 Pro Ra